|
| Chapter 18 Classifier |
| Table 42 | Advanced Application > Classifier (continued) |
| LABEL | DESCRIPTION |
| Ethernet | Select an Ethernet type or select Other and enter the Ethernet type number in |
| Type | hexadecimal value. Refer to Table 44 on page 154 for information. |
|
|
|
| Source |
|
|
|
|
| MAC | Select Any to apply the rule to all MAC addresses. |
| Address | To specify a source, select the second choice and type a MAC address in valid MAC |
|
| address format (six hexadecimal character pairs). |
|
|
|
| Port | Type the port number to which the rule should be applied. You may choose one port only |
|
| or all ports (Any). |
|
|
|
| Destination | |
|
|
|
| MAC | Select Any to apply the rule to all MAC addresses. |
| Address | To specify a destination, select the second choice and type a MAC address in valid MAC |
|
| address format (six hexadecimal character pairs). |
|
|
|
| Layer 3 |
|
| Specify the fields below to configure a layer 3 classifier. | |
|
|
|
| DSCP | Select Any to classify traffic from any DSCP or select the second option and specify a |
|
| DSCP (DiffServ Code Point) number between 0 and 63 in the field provided. |
|
|
|
| IP | Select an IP protocol type or select Other and enter the protocol number in decimal value. |
| Protocol | Refer to Table 45 on page 155 for more information. |
|
| You may select Establish Only for TCP protocol type. This means that the Switch will |
|
| pick out the packets that are sent to establish TCP connections. |
|
|
|
| Source |
|
|
|
|
| IP | Enter a source IP address in dotted decimal notation. |
| Address/ | Specify the address prefix by entering the number of ones in the subnet mask. |
| Address |
|
| Prefix |
|
|
|
|
| Socket | Note: You must select either UDP or TCP in the IP Protocol field before |
| Number | |
| you configure the socket numbers. | |
|
| |
|
| Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second |
|
| option and enter a TCP/UDP protocol port number. |
|
|
|
| Destination | |
|
|
|
| IP | Enter a destination IP address in dotted decimal notation. |
| Address/ | Specify the address prefix by entering the number of ones in the subnet mask. |
| Address |
|
| Prefix |
|
|
|
|
| Socket | Note: You must select either UDP or TCP in the IP Protocol field before |
| Number | |
| you configure the socket numbers. | |
|
| |
|
| Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second |
|
| option and enter a TCP/UDP protocol port number. |
|
|
|
| Add | Click Add to insert the entry in the summary table below and save your changes to the |
|
| Switch’s |
|
| power, so use the Save link on the top navigation panel to save your changes to the non- |
|
| volatile memory when you are done configuring. |
|
|
|
| Cancel | Click Cancel to reset the fields back to your previous configuration. |
|
|
|
| Clear | Click Clear to set the above fields back to the factory defaults. |
|
|
|
| 153 |
|
|