Chapter 30 DVMRP

 

Table 93

DVMRP (continued)

 

LABEL

DESCRIPTION

 

Index

Index is the DVMRP configuration for the IP routing domain defined under Network. The

 

 

maximum number of DVMRP configurations allowed is the maximum number of IP routing

 

 

domains allowed on the Switch. See Section 7.6 on page 83 for more information on IP

 

 

routing domains.

 

 

 

 

Network

This is the IP routing domain IP address and subnet mask you set up in IP Setup.

 

 

 

 

VID

DVMRP cannot be enabled on the same VLAN group across different IP routing domains,

 

 

that is, you cannot have duplicate VIDs for different DVMRP configurations (see Figure

 

 

135 on page 247).

 

 

 

 

Active

Select Active to enable DVMRP on this IP routing domain.

 

 

 

 

Apply

Click Apply to save your changes to the Switch’s run-time memory. The Switch loses

 

 

these changes if it is turned off or loses power, so use the Save link on the top navigation

 

 

panel to save your changes to the non-volatile memory when you are done configuring.

 

 

 

 

Cancel

Click Cancel to begin configuring this part of the screen afresh.

 

 

 

30.3.1 DVMRP Configuration Error Messages

You must have IGMP/RIP enabled when you enable DVMRP; otherwise you see the screen as in the next figure.

Figure 133 DVMRP: IGMP/RIP Not Set Error

When you disable IGMP, but DVMRP is still active you also see another warning screen.

Figure 134 DVMRP: Unable to Disable IGMP Error

Each IP routing domain DVMRP configuration must be in a different VLAN group; otherwise you see the following screen.

Figure 135 DVMRP: Duplicate VID Error Message

 

247

GS-4012F/4024 User’s Guide