Programming Groups
Once you have programmed some
1Press the SELECT FUNCTION key.
2Press the 8/LOCATION PROG.
LOCATION PROGRAMMING.
3On the numeric keypad, press the # key. The display shows
GROUP SETTING.
4Using the numeric keypad, enter the group number
5The display shows the number of your current group and SELECT LOC.(S). You can now add a location to your group (or delete a location from it). Refer to the instructions below.
To Do This | Use |
Add a | Press the |
| group. |
Add an Auto Dial location | Press AUTO DIAL. Enter the |
| Press START to add it to the group. |
Delete a previously added | Press the |
from the group. | |
Delete an Auto Dial | Press the AUTO DIAL key. Enter the |
location | number. Press START to delete it from the group. |
Search for a location | Press the SEARCH key continuously until the location |
by name to add or delete | appears. If the location is not yet in the group, press |
| START to add it. If the location is in the group, press |
| START to delete it. |
6After you have completed your selection (by pressing START key,
YES or NO , the display shows SELECT LOC. again. Continue to add or delete locations from your group. Each group can contain up to a maximum of all of the
7When you are finished programming your group, press The display shows LOCATION PROGRAMMING.
NO .
8To program another group, go back to Step 3. If you are finished, press the SELECT FUNCTION key.