Xilinx manual ML310 PM Utility Pins, Adapter Board PM Connectors, Contact Order

R

Chapter 2: ML310 Embedded Development Platform

•1 single-ended clock at 2.5V

•1 pin not connected

Adapter Board PM Connectors

Tyco Z-Dok+ adapter board connectors, part number 1367555-1 are the receptacle connectors on the personality modules that mate to the ML310 Tyco Z-Dok+ host board connectors, part number 1367550-5. The Tyco data sheet for part number 1367555-1 is available at http://www.z-dok.com/documents/1367555.pdf.

On the adapter board connectors, located on the personality module, each signal pair has a pair of ground pins on the opposite side of the open space, as shown in Figure 2-22. The signal pairs alternate from side to side along the length of the open space. All of the "B" and "E" pins are two contacts tied together and grounded on the personality module. The "A", "C", "D", and "F" pins are signal pins.

F 4

E 4

F 3

Plastic Housing

Copper Pins

	E 3		F 2		F 1		E 1
D 4		D 3		E 2		D 2		D 1

C 4

C 3

B 4

A 4

B 3

A 3

C 2

B 2

C 1

B 1

A 2

A 1

Figure 2-22:Adapter Board Connector Pin Detail

ML310 PM Utility Pins

Contact Order

The Z-Dok+ power and ground pins contact in the following order:

•1 and 6;

•then 2 and 5;

•then 3 and 4

64	www.xilinx.com	ML310 User Guide
	1-800-255-7778	UG068 (v1.01) August 25, 2004