Connecting The Power Supply
Plug the AC adapter into the AC Power Jack on the back of your phone, then into a standard electrical outlet or surge protector, if you are using one. For safety reasons, use only the AC120v DC9v 200mA adapter provided.
Note: The adapter is required for the telephone to work correctly.
Hanging The Phone On The Wall
You can place your phone on a flat surface or mount it on a telephone wall plate (not included).
To mount using an existing wall plate adapter.*
1 Connect one end of the short phone cord to the telephone wall plate and the other to the telephone
2Insert the supplied mounting bracket (the 3 ¾” x 1 ½” rectangle included with your phone) into the slots on the back of the phone and push the bracket up until it clicks. The keyhole opening should match the direction of the one above it. To detach the bracket, simply depress the tab with a Pen, Screwdriver, etc. to allow the bracket to slide down.
3Insert the two keyhole slots on the phone with the wall plate and slide the phone down, being careful not to pinch the telephone line, until the phone is secure.
4Press and lift out the handset holder. Remove the hanging peg (located by the switch hook) by pushing it upwards then rotate the peg 180 degrees, then snap it into place so it will hold the handset in place when the phone is mounted on the wall.
*If you do not have an existing wall plate adapter, they are available for purchase at most major electronic retailers or home improvement centers. Follow the manufacturers’ instructions for installation.
SET UP
Setting The Contrast
Press the MENU button. The display shows LCD CONTRAST.
Press the DIAL button. The display shows the current contrast setting with values between 1 and 5.
Press 
or 
to select the contrast level and confirm with DIAL button.
The display now shows to ENTER TIME/DATE, you can refer to next
section to set the time and date or press | button to exit the set- |
up mode. |
|
5 – ENGLISH