47
12Push in on the connector cover to lock the cable into place. See letter “D” in the figure.
13Install the chassis cover.
14Install the front bezel.
Removing a Floppy Drive from the Slim Line Drive bay with Altos R710
1Power down the server system and unplug all peripheral devices and the AC power cable.
2Remove the chassis cover.
3Remove the front bezel.
4Open the connector on the rear of the floppy drive by pulling up on the connector.
5Remove the data cable from the rear of the floppy.
6Push in on the blue lever at the rear of the drive carrier Remove the drive carrier at the left side of the chassis to release the drive carrier.
7Slide the drive carrier out through the front of the chassis.
8Press downward on the side of the drive tray and release the drive.
9Remove the small screw that attaches the interposer board to the drive.
10Store the screw and floppy carrier for future use. Suggestion: tape the screw and backplate to the top surface of the drive bracket.
11Install the slim line filler panel into
12If installing a new floppy drive start from step “Install a Slimline Floppy Drive into Altos R710”
13Install the chassis cover.
14Install the front bezel.
