53

Installing the SCSI 6th HD upgrade kit in Altos R710

The SCSI sixth HD upgrade kit is used when a sixth SCSI hot-swap drive is needed.

1.Power down the server and unplug all peripheral devices and the AC power cable.

2.Remove the chassis cover.

3.Remove the front bezel if it is installed.

4.Remove the drive blank from the sixth drive bay by using a long screwdriver to push it out through the front of the chassis.

TP01366

Figure 1. Remove the Drive Blank from the Chassis

5.Remove the fan module.

6.Hold the SCSI sixth drive board about ?-inch above the opening in the backplane to allow alignment notches to clear the top of the backplane bracket. Move the board forward into the opening and set it into place while lining up the two tabs on the sixth drive kit board

Page 65
Image 65
Acer manual Installing the Scsi 6th HD upgrade kit in Altos R710, Remove the Drive Blank from the Chassis