![](/images/new-backgrounds/1306544/306544119x1.webp)
48 | 4 Configuring the system |
Installing a Floppy Drive into the Converted Hard Drive Bay on Altos R710 Server System
The floppy drive conversion kit can only be installed into a system that is using the SCSI backplane. You will know if you have one of these backplanes installed if you can install
1.Power down the server and unplug all peripheral devices and the AC power cable.
2.Remove the chassis cover.
3.Remove the front bezel if it is installed.
4.Remove the upper left
5.Remove the screws that attach the slide rails to the floppy drive conversion kit carrier.
TP01307
Figure 1. Removing the Rails from the Floppy Drive Conversion Kit Carrier
6.Slide the floppy drive into the drive carrier, rear of the drive first, with the underside of the drive facing down.
7.Line up the holes in the side of the drive with the holes in the carrier. See letter "A" in the figure below.