Acer manual Install a Slimline Optical drive into Altos R710

59

Install a Slimline Optical drive into Altos R710

NOTE:The carrier for the slimline Optical drive was pre-installed in the slimline drive bay of your Altos R710 Server You will need to remove it from the chassis before beginning.

1Power down the server system and unplug all peripheral devices and the AC power cable.

2Remove the chassis cover.

3Remove the front bezel.

4Align the two holes at left edge of DVD-ROM /CD-ROM drive with the cutouts in drive carrier. See letter “A” in the figure below.

5Lower the right side of the DVD-ROM / CD-ROM drive into the carrier until it clicks into place. See letter “B” in the figure below.

6Use the two screws indicated in the figure to attach the interpose board to the DVD-ROM / CD-ROM drive. See letters “C” and “D” in the figure.

7Attach the 44-pin CD-ROM drive cable to the exposed side / back of the interposer board. See letter “E” in the figure.

E

D

D
C	B
A

8Insert the DVD-ROM / CD-ROM drive into the chassis. See letter “A” in the figure below.