52 | 4 Configuring the system |
Removing a Floppy Drive from the Converted Hard Drive Bay
1.Power down the server and unplug all peripheral devices and the AC power cable.
2.Remove the chassis cover.
3.Remove the front bezel if it is installed.
4.Open the connector labeled "Floppy Con" on the backplane by pulling up on the connector cover. Remove the flat flex cable from the backplane.
5.Push in on the lever at the rear of the floppy carrier and slide the drive from the front of the chassis.
6.Open the connector cover on the rear of the floppy drive by pulling up on it. Release the flat flex cable from the drive.
7.Remove the two screws at each side that hold the drive rails to the drive carrier. Lift the two rails from the carrier.
8.Disconnect the two screws attaching the drive to the converted hard drive bay carrier.
9.Install an empty
10.Store the screws, the converted drive bay carrier, the side rails, and the flat flex cable for future use.
11.Install the chassis cover.
12.(Optional) Install the front bezel.
13.Plug all peripheral devices and the AC power cable back into the server.