Tool Compensation Path

Path of Tool During Tool Compensation

In linear-to-linear or linear-to-circular moves, the position at the end of the startup block Compensation LEFT (G41), or Compensation RIGHT (G42), is perpendicular to the next programmed move in the plane.

In either case, the axes moves to a point perpendicular to the next move during the startup block.

The length of the XY move that activates compensation must be equal to or greater than the tool radius value. Example: If tool radius equals 0.3750", the vector length of the XY move that activates compensation must be 0.3750" or greater.

The same applies to Compensation OFF move (G40).

During tool compensation, the CNC performs offset correctly and automatically. Non-positioning moves such as dwells (except dwell zero or infinite dwells), coolant, or other auxiliary functions are allowed (except Optional Program Stop, and Program Stop Mode, these are not allowed). Moves in the third axis are also allowed during compensation.

It is recommended to use the previously described Entry and Exit moves.

4.2 Tool Data

ACU-RITE 3500i

81

Page 107
Image 107
Acu-Rite CNC 3500i user manual Tool Compensation Path, Path of Tool During Tool Compensation