Acu-Rite CNC 3500i user manual Rapid Move Radius and Y, Line Move, 123

Rapid Move - Radius and Y:

Specify the desired end point coordinate using actual position designations, either in absolute or incremental.

Field Code Description

YY Absolute position of, or incremental distance to, the desired Y-Axis destination. (Required)

Radius	R	Absolute or incremental distance to the
		desired destination. (Required)
	Z	Absolute position of, or incremental
		distance to, the desired Z-Axis destination.
ToolComp	T	Select the modal tool diameter
		compensation to activate or select Off to
		deactivate comp.

Line

Line Move:

Line Move initiates a straight-line feed motion and is used to cut a part. Straight-line motion occurs in one or more axes. The block may contain any combination of available axes.

One to four axes can be included on a block with Line Move.

X, Y, Z, and U reach the target simultaneously.

Line Move is modal, and remains in effect until canceled or overridden.

Line Move can be programmed in absolute or incremental, and follows the active mode.

Specify the feedrate of the movement on or prior to the Line Move block.

Conversational format: Line

G-code format: G1

Press the Other button to select the Line Move variant that best fits your needs. Each variant is described next. The following figure visually depicts the Angle and Radius parameters used in some of these variants to specify the desired end point coordinate.

7.1 Explaining Basic Cycles

ACU-RITE 3500i 123