Acu-Rite CNC 3500i user manual 203

Field	Code	Description
DistDown	E	The incremental distance from the
		current Z Retract amount to go down
		along the side of the probe stylus when
		doing a diameter pick. The maximum E
		value is 0.55" (13.97 mm) or the tool may
		crash into the probe or table. If you enter
		a value larger than 0.55" (13.97 mm), the
		control issues an error message. If E is
		not set, the cycle uses a default value of
		0.1" (2.54 mm). (Optional) [Default: 0.1"]
		Ball nose cutters and special cutters that
		require a move down more than 0.55"
		(13.97 mm) are not supported.
		NOTE: Z Retract Amount is set in the
		Tool Probe Parameters.
OvrFstFeed	F	This is the override for the fast Z feedrate
		that was set in the machine setup
		parameter ZFirstPickFeedRate_Fast.
		Sometimes there may be a tool that has
		a large diameter making it necessary to
		slow it down to prevent the touch probe
		from being hit too hard. This can only be
		set slower. Trying to set this higher will
		result in the software using the original
		feedrate. (Optional)
OvrMedFeed	M	This is the override for the medium
		feedrate that was set in the machine
		setup parameter
		ZFirstPickFeedRate_Medium. This is
		used for the same reason as the F cycle
		parameter. This can only be set slower.
		Trying to set this higher will result in the
		software using the original feedrate.
		(Optional)

7.3 Probing Cycles

ACU-RITE 3500i 203