G-Code

Description

Label

G169

Use to mill irregular pockets.

Irregular Pocket Cycle

 

 

 

G170

Facing cycles simplify the programming required to face the

Face Mill Cycle

 

surface of a part.

 

 

 

 

G171

The Circular Profile Cycle cleans up the inside or outside profile of

Circular Profile Cycle

 

an existing circle.

 

 

 

 

G172

The Rectangular Profile Cycle cleans up the inside or outside

Rectangular Profile Cycle

 

profile of a rectangle.

 

 

 

 

G175

Start of Mill Cycle.

Mill Cycle

 

 

 

G176

The mill cycle is terminated with the end mill block; at which

End Mill Cycle

 

point, it rapids up to the Start Height and rapids to the X and Y

 

 

location specified. If X and Y are not specified the tool remains in

 

 

the current position.

 

 

 

 

G177

Use the plunge circular pocket cycle for carbide tooling, when a

Plunge Circ Pocket Cycle

 

multiple-axis ramp-in move is not possible. The Z-axis plunges

 

 

(single-axis) to programmed depths.

 

 

 

 

G178

Use the plunge rectangular pocket cycle for carbide tooling,

Plunge Rect Pocket

 

where a multiple-axis ramp-in move is not possible. The Z-axis

 

 

plunges (single-axis) to the programmed depth.

 

 

 

 

G179

Use the automatic hole pattern canned cycle to program partial or

Drill Pattern Cycle

 

full pattern hole grids. Also used for a corner pattern when holes

 

 

are required only on four corners.

 

 

 

 

G181

Use the thread mill cycle for cutting inside or outside threads. It

Thread Mill Cycle

 

cuts either Inch or MM, left or right hand, and Z movement up or

 

 

down. A single tooth, or multi-toothed tool may be used.

 

 

 

 

G190

Use the engrave cycle to engrave part numbers, legends, or any

Engrave Cycle

 

alpha/numeric inscription. The usual type of cutter is a sharp point

 

 

or center-drill type tool.

 

 

 

 

G191

Use the arc engrave cycle to engrave part numbers, legends, or

Arc Engrave Cycle

 

any alpha/numeric inscription in an arc. The usual type of cutter is

 

 

a sharp point or center-drill type tool.

 

 

 

 

G210

Use the slot cycle to mill a slot.

Slot Cycle

 

 

 

G211

Use the circular slot cycle to mill a slot along a circular path.

Circular Slot Cycle

 

 

 

F

Use to set the feed rate.

Feed rate

 

 

 

11.2 G-Code and M-Code Definitions

ACU-RITE 3500i

367

Page 393
Image 393
Acu-Rite CNC 3500i user manual End Mill Cycle, 367