7.3 Probing Cycles

Tool Breakage, Length and Diameter Wear Detection

Checks the tool and gives an alarm if not within tolerance. Length and Diameter Wear - Check the Length and/or Diameter and updates the Length and/or Diameter wear registers up to a user-defined limit. Once the user-defined limit has been reached, the cycle gives an alarm and the program stops.

Field

Code

Description

Tool#

T

Tool number. (Required)

 

 

The T cycle parameter is the tool number

 

 

you want checked.

 

 

 

EstDiam

D

This is the rough diameter on the bottom of

 

 

the tool. (Optional)

 

 

The diameter specified in this parameter

 

 

should be roughly the diameter on the

 

 

bottom of the tool that you want to be over

 

 

the center of the probe stylus. If you have a

 

 

left-handed tool, you would give a negative

 

 

value to this diameter so the spindle turns

 

 

on forward verses reverse. When stepping

 

 

over for checking the diameter of the tool,

 

 

this cycle uses the diameter in the tool table

 

 

for the tool being checked.

 

 

 

MaxLen

K

The maximum length wear value limit. The

Adj

 

cycle checks to see if the cutter length has

 

 

changed by more than this amount and

 

 

triggers the alarm, stopping the program if

 

 

exceeded. If not set, the cycle does not

 

 

check the tool length. (Optional)

 

 

At least one, K or J must be set or the cycle

 

 

alarms.

 

 

 

MaxDia

J

The maximum diameter wear value limit.

Adj

 

The cycle checks to see if the cutter

 

 

diameter has changed by more than this

 

 

amount and alarms, stopping the program if

 

 

exceeded. If not set, the cycle does not

 

 

check the tool diameter. (Optional)

 

 

At least one, K or J must be set or the cycle

 

 

alarms.

 

 

 

214

7 Programming: Canned Cycles, sub-programs

Page 240
Image 240
Acu-Rite CNC 3500i user manual Tool Breakage, Length and Diameter Wear Detection