Chapter 6. Data Port Configuration
Management DLCI (MGMT DLCI)
To use local PVC management, enter the management data link connection identifier (DLCI). The MANAGEMENT DLCI is a special DLCI used between the attached DTE device and the TSU IQ+ to carry SNMP and TELNET packets to/from the TSU IQ+ on the DTE port.
Guidelines for Configuring Management DLCI
If the attached router or FRAD is used to route SNMP/TELNET frames to the TSU IQ+, set the MANAGEMENT DLCI to a unique value (between 16 and 1007) that identifies the virtual circuit between the router/FRAD and the TSU IQ+. The router/FRAD must also be configured to route the TSU IQ+ IP address to this DLCI. The IP ADDRESS and SUBNET MASK for the DTE (V.35) port must also be set in the SYSTEM CONFIGURATION menu.
Management PVC Option (MGMT PVC OPT)
If this option is set to ENABLED, the management DLCI is included in the Full Status response to the router. Enable this option when the management DLCI is used to route management traffic to the TSU IQ+. Options are ENABLED and DISABLED.
Signaling Responses (SIG RESPONSES)
This option determines when PVC SIGNALING RESPONSES are sent to the router.
Always On
If enabled, PVC SIGNALING RESPONSES are sent to the router regardless of the network signaling state. Enable this option when the TSU IQ+ is used for dial backup.
Follow Network (FOLLOW NET)
If enabled, PVC SIGNALING RESPONSES are sent to the router only when the network signaling state is up. Enable this option when the router is going to use an alternate path for dial backup.
Always Off
If enabled, PVC signaling responses are NOT sent to the router, regardless of the network signaling state. Enable this option to simulate a PVC failure when the router is going to use an alternate path for dial backup.
TSU IQ+ User Manual |