ADTRAN TSU IQ+, 1204002L2 user manual Power Up, Rear Panel, Customer Provides

Chapter 2. Installation

The following items are included in ADTRAN shipments of DBU cards:

•DBU card

•An 8-position modular to 8-position modular cable for the 4-wire SW56, ISDN, or PRI DBU options or an 8-position modular to 4-position modular cable for the V.34 DBU option

Customer Provides

The customer must provide a male V.35 interface cable.

For SNMP management not accessed through the V.35 or Network port, the customer must provide access to the TSU IQ+ either through a SLIP, Async PPP (requires a male 25-pinD-type connector), or a through the 10BaseT Ethernet port (requires that an ADTRAN Ethernet card be installed in the TSU IQ+). See Pinouts on page A-1 for the pin assignments of the CONTROL port (for SLIP and Async PPP) and the ETHERNET port.

Power Up

The TSU IQ+ is provided with a captive 8-foot power cord, terminated by a three-prong plug which connects to a grounded 115 VAC power receptacle.

Power to the TSU must be provided from a grounded 115 VAC, 60 Hz re- ceptacle.

REAR PANEL

The rear panel contains a DTE connector which provides primary channel V.35. An 8-pin Network jack, Test Jacks, a DSX-1 port, a Control port, a captive power cord, and a power switch are also located on the rear panel. Pin assignments for these connectors are

2-2 TSU IQ+ User Manual 61200275L1-1