
Chapter 2. Installation
DBU and LAN Card Slots
The TSU IQ+ rear panel has two card slots (labeled DBU Interface and LAN Interface) for the installation of dial backup, ethernet, and DCE cards. To insert cards, perform the following procedure:
1.On the rear panel, turn off the power switch.
2.Slide the card into the corresponding rear slot until the card panel is flush with the TSU IQ+ chassis.
3.Push card locks in (until they click) to secure the card and ensure proper installation.
Card slots are keyed to prevent improper installation (i.e., putting a DBU card into the ethernet slot). The DCE card is keyed for the DBU slot.
Failure to remove power from the unit before installing or removing op- tion cards can damage the equipment.
Network Connector
Connect the TSU IQ+ to the network by using the
Test Jacks
Monitor
The monitor jack (labeled MON) is used as a
In/Out
The IN and OUT jacks are used to connect to a T1 test set for testing the T1 interface of the TSU IQ+. These connections isolate the T1 interface from the
TSU IQ+ User Manual |
|