Agilent Technologies 16700B manual Cable end that connects to the high-density AMP Mictor

Chapter 6: Connecting Accessories

38-pin Low-voltage Probe (E5339A with tip isolation network)

	38-pinLow-voltage Probe (E5339A with tip isolation network)
NOTE:	For all Agilent logic analyzers except 16517A, 16518A, 16760A, and
	16753/54/55/56A.
	The 38-pin low-voltage probe provides a convenient way to connect
	two Agilent Technologies logic analyzer probe cables to a small area of
	a target system. The Agilent E5339A probe has isolation networks in
	the cable end that connects to the high-density AMP MICTOR
	(Matched Impedance ConnecTOR) connector. It is designed to be
	compatible with low-amplitude digital signals, down to 250 mV p-p.

Logic Analyzer

Pod

AMP "MICTOR 38"

Connector Pinout

Probe Cable

(with RC network)

+5VDC		1
GND DC		3
	CLK	5
	D15	7
	D14	9
Pod	D13	11
	D12	13
	D10	17
	D11	15
Even	D9	19
	D8	21
	D7	23
	D6	25
	D5	27
	D4	29
	D3	31
	D2	33
	D1	35
	D0	37

2	Do not connect
4	Do not connect
6	CLK
8	D15
10	D14
12	D13
14	D12	Pod
18	D10
16	D11
20	D9	Odd
22	D8
24	D7
26	D6
28	D5
30	D4
32	D3
34	D2
36	D1
38	D0

Note: +5V is supplied from the logic analyzer to provide power for analysis probes and demo boards. DO NOT connect these pins to a +5V supply in the target system!

Shroud

Amp "MICTOR 38”

Equivalent Load

220 ohm

Signal

50.5k

Connector

3pF 18pF

Ground

ohm

Includes logic analyzer and MICTOR connector.

103