Chapter 6: Connecting Accessories
38-pin Adapter Cable (E5351A no tip network)
| |
|
|
NOTE: | For all Agilent logic analyzers except 16517A, 16518A, 16760A, and |
| 16753/54/55/56A. |
| The |
| |
| Agilent Technologies logic analyzer probe cables to a small area of a |
| target system. The Agilent Technologies E5351A adapter cable does |
| not have isolation networks, so isolation networks must be provided on |
| the target system. |
AMP "MICTOR 38" Connector Pinout | Logic Analyzer |
(Top View) | Pod |
+5VDC | 1 | |
GND DC | 3 | |
| CLK | 5 |
| D15 | 7 |
| D14 | 9 |
Pod | D13 | 11 |
D12 | 13 | |
| D11 | 15 |
Even | D10 | 17 |
D6 | 25 | |
| D9 | 19 |
| D8 | 21 |
| D7 | 23 |
| D5 | 27 |
| D4 | 29 |
| D3 | 31 |
| D2 | 33 |
| D1 | 35 |
| D0 | 37 |
2 | Do not connect |
|
|
| |
4 | Do not connect |
|
|
| |
6 | CLK |
|
|
|
|
8 | D15 |
|
|
|
|
10 | D14 |
|
|
|
|
12 | D13 | Pod |
|
|
|
14 | D12 |
|
|
| |
16 | D11 | Equivalent Load |
| ||
18 | D10 |
| |||
20 | D9 | Odd | 370 |
|
|
22 | D8 |
|
| ||
24 | D7 |
| ohm |
|
|
26 | D6 |
| Signal |
|
|
28 | D5 |
|
|
| 100k |
30 | D4 |
| 0.3pF | 9pF | |
32 | D3 |
| ohm | ||
|
|
| |||
34 | D2 |
|
|
|
|
36 | D1 |
| Ground |
|
|
38 | D0 |
|
|
|
|
Includes on board RC network and logic analyzer
Suggested On-board RC Network 
Adapter Cable
Shroud
Note: +5V is supplied from the | 250 | 90.9k |
| |
ohm | ohm |
| ||
logic analyzer to provide power | Signal |
| To | |
for analysis probes and demo |
|
| ||
|
| |||
boards. DO NOT connect these |
| 10pF | ||
| Adapter Cable | |||
pins to a +5V supply in the | Ground | |||
|
|
target system!
Amp "MICTOR 38"
Connector
NOTE: | Agilent Technologies recommends two types of RC networks. They are |
| described in detail in Probing Solutions for Agilent Logic Analysis Systems. |
| Go to http://www.tm.agilent.com/classes/ProdSearch to download this |
| application note. Type in the title, select go, and the document will be listed |
| under the section Application Notes & Technical Papers. |
|
|
105
