Agilent Technologies E6385A Sbe f-w sv Rwu dwxww dwuw-w, Muuw, My-w fwuzy-w66M CD9? Nsesuw W

Product Description

Optional Equipment

aw

W–±u“zmx ±q—± q•®u–yqz± mzp “±tq” “–±u“zmx u±qy— m”q pq—o”unqp uz ±tq r“xx“uzs —qo±u“z—4

Sbe f–w sv Rwu dwxww dwuw–w

]tq ]q—± [“r±m”q —®––“”±— ±tq [yyq±”uo“y ;?;69I OX[ ]uyq mzp N”q•®qzo Zqrq”qzoq Zqoqu©q” r“” —®––xtq ±uyqnm—q —uszmx z“”ymxxmwqz r”“y ±tq Jm—q [±m±u“z q•®u–yqz±4

ctqz o“zzqo±uzs ±“ ±tq Jm—q [±m±u“z [K] y“p®xq— m— ±tq ±uyuzs ”qrq”qzoq2 ±tq ]q—± [“r±m”q ®—q— ±tq —uszmx— “®± “r ±tq y“p®xq— m— ±t“®st ±t“—q —uszmx— m”q o“””qo±x ±uyqp ±“ OX[ ±uyq ±“ –”“©upq ±tq o“””qo± XV “rr—q± .—qq “Test Set to GPS Time and Frequency Reference Receiver Connections” on page 50). If a problem exists in the Base Station GPS reference or SCT modules, the Base Station PN offset will likely be incorrect.

Use of the 58503A provides a GPS-referenced timing signal that is independent of the Base Station. This helps isolate problems associated with the Base Station own GPS reference equipment and/or SCT module(s). An example of this is an “island cell”, where the Base Station passes performance tests but does not properly interact with adjacent cells during handoffs.

Muuw–

Several kits containing selections of accessories for connecting the Test Set to the Base Station equipment are available from Agilent Technologies. These are described in the following three sections.

My–w fwuzy–w66M CD9? Nsesuw W–

The Agilent Technologies E8300A 8935 Base Station Accessory Kit (see Table 1-1) supplies serial cables, RF cables, and adapters required to connect the Test Set for testing Base Stations.

	.
fstw 737	QC966M Nsesuw W–O
bs		bs Ztw c–	gw
Cable Assembly,		08921-61010		1	Connects the Base Station TX Antenna Port
N(M) to N(M), 10-ft.					to the Test Set RF IN/OUT port.
Cable Assembly,		08921-61021		2	Connects Base Station Even Second clock
SMA(M) to BNC(M), 10-ft.					and 19.6608-MHz clock to Test Set.
Cable Assembly,		E8300-61002		1	Connects the Base Station TX Test Port to
SMA(M) to N(M), 12-ft.					the Test Set ANT IN port.
Cable Assembly,		E8300-61005		1	Used as the calibration cable for Insertion
N(M) to N(M), 2-ft.					Loss test.
Null Modem Cable Assembly,		5182-4794		1	Connects the PC serial port to the Test Set
DB9(F) to DB9(F), 10-ft.					SERIAL 9 port.

Product Description

Chapter 1 17