Agilent Technologies E6385A manual Configuring the Test Software

Installation

Configuring the Test Software

ew A4 [qxqo± ±tq TX Antenna Port Cable Loss [dB] ruqxp2 ”“±m±q ±tq wz“n ±“ ±tq x“—— ©mx®q r“” ±tq omnxq ±tm± ® o“zzqo± r”“y ±tq ]q—± [q± ZN QV5Wa] –“”± ±“ ±tq Jm—q [±m±u“z ]d Iz±qzzm –“”±2 mzp –”q—— ±tq wz“n ±“ —qxqo± u±4 Qr “® m”q ®zoq”±muz “r ±tq omnxq x“—— ©mx®q2 ”®z ±tq “TX Antenna Port Cable Calibration Test” on page 75 to measure and enter the value automatically.

ew B4 Select the TX Test Port Cable Loss [dB] field, rotate the knob to the loss value of the cable that you connect from the Test Set ANT IN port to the Base Station TX Test Port, and press the knob to select it. If you are uncertain of the cable loss value, run the “TX Test Port Cable Calibration Test” on page 76 to measure and enter the value automatically.

ew C4 Select the TX Antenna Port Coupling Factor [dB] field, rotate the knob to the value of the loss through the directional coupler used to provide the transmitter signal to the Base Station TX Test Port, and press the knob to select it. The Test Software will use this value to calculate the transmitter true power output without the requirement for disconnecting the transmit antenna from the TX Antenna port. If you are uncertain of the coupling factor value, run the “TX Test Port Calibration Test” on page 77 to measure and enter this value automatically.

40 Chapter 2

O:\Manuals\E6385A_Cdma\Book\Install.fm