Performing Tests

Pilot Only Test

ew 74

ew 84 ew 74

NOTE

b– aw

]tu— ±q—± –q”r“”y— m —®u±q “r KLUI ±q—±— “z m om””uq” u±t “zx ±tq –ux“± otmzzqx mo±u©q

.z“ mo±u©q ±”mrruo “” –msuzs otmzzqx—/4 ]tq”qr“”q2 ±tu— ±q—± ymq –q”r“”yqp “zx ±t ±tq Jm—q [±m±u“z “®±3“r3—q”©uoq4

]tq ±q—±— –q”r“”yqp m”qB

Rho (modulation quality)

Pilot Time offset

Frequency error

Carrier feedthrough

bsws ewu–x–us g

The following specifications and parameters are used when running this test. See Chapter 5, “Reference,” for descriptions of the specifications and parameters.

bssww E

• None

ewu–x–us .bs5Rs– X––/E

1. Carrier Feedthrough

5. Frequency Error

8. Rho

9. Time Offset

ewwu dw fw

Perform the Pilot Only Test as follows:

From the Lucent CDMA Tests Main Menu screen, select the Test Selections field. The Test Software will display the Test Selections Menu screen.

Select the Pilot Only Test field.

Follow the displayed instructions and diagram to make the measurement.

This procedure might include steps that prompt you to disconnect cables from the site antenna ports and make connections to the Test Set. Before removing or re-installing the antenna cables, make certain that the transmitter has been turned off by the MSC (or by switch personnel if not using a modem). The green ACT LEDs on the ACU and BCR modules indicate the transmitter is active, and therefore should be off before disconnecting cables.

62

Chapter 4

O:\Manuals\E6385A_Cdma\Book\perf-tst.fm

Page 61
Image 61
Agilent Technologies E6385A manual Pilot Only Test