Agilent Technologies E6385A manual Fj fw b Ost Oss- fw

Performing Tests

TX Test Port Cable Calibration Test

fj fw b Ost Oss– fw

]tu— ®±uxu± yqm—®”q— ±tq —uszmx x“—— ±t”“®st ±tq omnxq ®—qp ±“ o“zzqo± ±tq ]q—± [q± ±“ ±tq Jm—q [±m±u“z ]d ]q—± X“”±4 ]tu— u— ±tq Jm—q [±m±u“z –“”± ±tm± —my–xq— ±tq ±”mz—yu±±q” “®±–®± “r ±tq JKZ ±t”“®st m pu”qo±u“zmx o“®–xq”4 ]tu— x“—— y®—± nq wz“z tqz ymwuzs –“q” yqm—®”qyqz±—4 Wzoq ±tu— ©mx®q u— yqm—®”qp2 “® —t“®xp xmnqx ±tq omnxq uzpuom±uzs ±tq x“—— ±t”“®st u± r“” r®±®”q ®—q4 ]tu— ®±uxu± —qzp— z“ o“z±”“x o“yymzp— ±“ ±tq U[K4

]tu— ”“®±uzq ”q•®u”q— ±tq ®—q “r ±“ q±q”zmx = pJ m±±qz®m±“”— .–mp—/ mzp m —t“”± omxun”m±u“z omnxq4 ]tq—q –m”±— m”q z“± —±mzpm”p q•®u–yqz± u±t ±tq ]q—± [q±2 n®± m”q

uzox®pqp uz ±tq “–±u“zmx mooq——“”±— .—qq “Accessory Kits” on page 17).

bsws ewu–x–us g

The following specifications and parameters are used when running this test. See

Chapter 5, “Reference,” for descriptions of the specifications and parameters.

bssww E

•21. TX Test Port Cable Loss

ewu–x–us .bs5Rs– X––/E

None used for this test.

ewwu dw g––

Perform the TX Test Port Cable Calibration routine as follows:

ew 74 From the Lucent CDMA Tests Main Menu screen, select the Calibration/Utilities field. The Test Software will display the Calibration/Utilities Menu screen.

ew 84 Select the TX Test Port Cable Calibration field.

ew 94 Follow the displayed instructions to connect the 6-dB pads and calibration cable, then press the k1 (Proceed) key.

ew :4 Follow the displayed instructions to connect the test cable in series with the calibration cable and pads, then press the k1 (Proceed) key.

dww dw

The Test Software will display the measured insertion loss and test frequency. Press the k1 (Proceed) key to continue. The Test Software will display a query asking if you wish to store the insertion loss as the TX Test Port Cable Loss. Use the knob to select Yes or No.

•If you select Yes, the Test Software will enter the value in the Test Configuration Menu screen automatically. Unless you believe that the indicated loss is incorrect, you should select Yes.

•If you select No, the Test Software will display a query asking if you wish to Remeasure the loss or Return to the Calibration/Utilities Menu screen.

76 Chapter 4

O:\Manuals\E6385A_Cdma\Book\perf-tst.fm