Agilent Technologies N2620A user manual Use

System Operations 4

Setting up the Optional Auxiliary Port

To change the network settings of the Auxiliary port, click on the edit button and the Auxiliary port setup screen will appear.

C A U T I O N	MAC address modification is not advisable.
	If a modification is unavoidable, the changes
	should be done with extreme care so that it
	will not conflict with any MAC address that is
	in use.

•MAC Address - The MAC Address of the FrameScope usually contains a value set in the factory. But this field can be used to change the MAC address if this is necessary for a specific case or to satisfy security requirements.

The MAC address can be reset to the factory default on the next boot-up by turning “Restore Default MAC” on in the System Settings.

You can use DHCP to automatically configure the FrameScope when connected to the network, or manually configure the IP details. If you manually configure, you are required to at least enter a valid IP address and a valid subnet mask.

•IP Address – This value uniquely identifies the FrameScope in the TCP/IP network.

•Subnet Mask – This value is combined with the IP Address to define the subnet to which the FrameScope belongs.

•Default Gateway – This is the default gateway (router) the FrameScope will use to communicate with devices on other subnets.

If you make changes, a pop-up will appear asking you to restart the FrameScope Pro for the new settings to take affect.

Agilent FrameScope Pro User’s Manual 119