The Throughput Settings screen.
Select the frame
direction to measure.(if destination is loopback only bidirectional options is present)
Max Data Rate is used for initial frame speed and performance calculation. Enter the maximum data rate of the network under test. If not known, the link speed will be used.
Specify the frame length (minimum 
of 64 bytes to maximum of 1518
bytes) or select full range to collect all frames of lengths 64, 128, 256, 512, 768, 1024, 1280, and 1518).
The Latency Settings screen.
The Latency test automatically uses values set for the Throughput test.
If a frame length is set for the throughput test, this cannot be changed for the latency test.
Network Testing with the FrameScope Pro | 2 |
Performance Tests
Select to measure full range or specify the upstream and downstream rates.
Network connection speed
Duration is the time taken (in seconds) to transmit frames that could be of different length, at different rates.
For better results, adjust the duration to load the device under test sufficiently.
Specify the frame length or select full range to collect all frame lengths.
Specify the number of round-trips for the test.
For better results, adjust the duration to load the device under test sufficiently.
Specify the upstream and downstream utilization rates when performing the Latency test.
Agilent FrameScope Pro User’s Manual | 63 |
