Alliance Laundry Systems 000 BTU, 105, 250 C.F.M, 80 To reduce the risk of fire:

Section V

Operating Instructions

WARNING

To reduce the risk of fire:

•DO NOT DRY articles containing foam rubber or similarly textured rubberlike materials.

•DO NOT DRY plastics, anything containing wax or chemicals such as mops and cleaning cloths, or anything dry-cleaned at home with a dry-cleaning solvent.

•DO NOT TUMBLE fiberglass curtains and draperies unless the label says it can be done. If they are dried, wipe out the cylinder with a damp cloth to remove particles of fiberglass.

W076

WARNING

To reduce the risk of serious injury, open tumbler door and allow cylinder to stop before cleaning lint screen. Do not operate without lint panel in place.

W077

MANUAL DUAL TIMER TUMBLER

1.Energize the electrical circuit to the tumbler at the disconnect switch or the circuit breaker.

2.Open the lint panel and check for any accumulated lint on lint screen. Close panel tightly against tumbler frame and lock panel securely.

3.Open the loading door and load the cylinder with laundry. Overloading will result in excessive drying time, wrinkled laundry, and wear to cylinder bearings.

4.Set the TEMPERATURE selector at HIGH (cotton load) (190°F, 88°C) , MEDIUM (mixed load) (162°F, 72°C), LOW (Permanent Press) (140°F, 60°C), or anywhere between these settings. The type of fabric being dried will determine the setting.

5.Set the DRYING selector for the number of minutes desired.

6.Set the COOLING selector for the number of minutes desired.

7.Press the PUSH-TO-START button in and hold it in for approximately three seconds. This starts the tumbler cycle.

ALWAYS FOLLOW THE FABRIC CARE INSTRUCTIONS SUPPLIED BY THE GARMENT MANUFACTURER.

The following steps outline the procedure for operating a tumbler through a complete drying cycle.

IMPORTANT: If the loading door is opened during the cycle, the heating system will shut off and the motor will stop. To restart the cycle, door must be closed and the PUSH-TO-START button must be pressed in and held for approximately three seconds.

8.When the cycle is completed, open door and remove the laundry.

M414545 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 51