D.Special Time Mode

This mode is just like the Time Dry mode, except that the regulating temperature for each heat cycle ranges from 80°F to 180°F. To enter the Special Time mode, press the SPECIAL TIME pad after selecting a cycle. The display will read “St:**”, where “**” is the drying time. This time can be changed by pressing the MORE or LESS pads. For 1 minute changes, press the pad and release. For 5 minute changes, press the pad and hold. Maximum drying time allowed is 60 minutes.

AC:** will be displayed when tumbler is in Auto Cool Down. Typical cool down times for fabric selections are preset. Refer to Table 9. The cool down time can only be altered before cycle is started. To alter cool down time press the COOL DOWN pad and then press the MORE or LESS pad (when cool down time is altered, TC:** will be displayed). For 1 minute changes, press pad and release. For 5 minute changes, press pad and hold. Cooling time can be from 1 to 39 minutes. To return to the Auto Cool Down, press MORE or LESS pad until AC:** is displayed.

To start the cycle, press START. The total drying time plus cool down time will display. During the cycle, remaining time displays.

E.Custom

Frequently used cycles can be saved in the control’s memory as Custom cycles. Only one cycle can be saved for each fabric type.

Create an Automatic, Time Dry, Special, or Special Time cycle using instructions in section 4A, 4B, 4C or 4D. Save by pressing the word CUSTOM before pressing START. To change a Custom cycle, repeat above.

To recall and use a Custom cycle, press its ON/ SELECT pad twice. Press START.

During Custom cycles the display is the same as non-Custom Automatic cycles. The CUSTOM status light will be on.

When creating or changing a Custom cycle, record it on a Custom Cycle Record. Refer to Figure 30. To modify or fine-tune a Custom cycle, its values must be known. Custom cycle values can be extracted from the micro-control, but it is easier and more permanent to use the Custom Cycle Record.

M414545

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

59