Alliance Laundry Systems 000 BTU, 105, 250 C.F.M, 80 INTRODUCTION, Special Time, Special Cycle, NOTE: Not all tumblers will have reversing option

ELECTRONICALLY CONTROLLED OPL TUMBLER

INTRODUCTION

Drying can be done automatically or by time dry. When drying automatically, the tumbler stops drying when laundry reaches the factory set or programmed dryness level and starts cool down. When time drying, the tumbler stops drying when programmed time ends and starts cool-down.

Special Cycle allows user to specify the number of heating cycles and specify temperature from 80°F (27°C) to 180°F (82°C) for all heat cycles.

Special Time allows user to specify temperature from 80°F (27°C) to 180°F (82°C) for all heat cycles.

Both automatic and time dry have factory-set cycles, but other cycles can also be created. Frequently used cycles can be saved in the control's memory as Custom cycles. Refer to Figure 25.

A drying instructions chart is included for recording selections and settings for various load types. Refer to Figure 31.

In all cycles, except No Heat, Wrinkle-Free begins when Cool Down ends. During Wrinkle-Free, the tumbler alternately stops for 2-1/2 minutes and then runs without heat for 2-1/2 minutes until door is opened or 60 minutes has elapsed.

All pads can be pressed in any sequence without damaging control or tumbler. To stop the tumbler at any time, open the door or press STOP/RESET. The window display will flash. Press STOP/RESET twice (within 3 seconds) to end the cycle and reset the control to idle status. Refer to Figure 24.

NOTE: Not all tumblers will have reversing option.

OPL Micro Control Panel

Figure 24

54 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M414545