Manuals / Brands / Laundry Appliance / Clothes Dryer / Alliance Laundry Systems / Laundry Appliance / Clothes Dryer

Alliance Laundry Systems 000 BTU, 105, 250 C.F.M, 80 DO NOT, ALWAYS, DO NOT, DO NOT, This machine is intended for commercial use

1 144

Download 144 pages, 2.58 Mb

17.Do not put articles soiled with vegetable or cooking oil in the tumbler, as these oils may not be removed during drying. Due to the remaining oil, the fabric may catch on fire by itself.

18.To reduce the risk of fire, DO NOT put clothes which have traces of any flammable substances such as machine oil, flammable chemicals, thinner, etc. or anything containing wax or chemicals such as in mops and cleaning cloths, or anything dry-cleaned at home with a dry-cleaning solvent in the tumbler.

19.Use the tumbler only for its intended purpose, drying fabrics.

20.ALWAYS disconnect the electrical power to the tumbler before servicing. Disconnect power by shutting off appropriate breaker or fuse.

21.Install this tumbler according to these INSTALLATION INSTRUCTIONS. All connections for electrical power, grounding, and gas supply must comply with local codes and be made by licensed personnel when required. Do not do it yourself unless you know how!

22.Remove laundry immediately after the tumbler stops.

23.Always read and follow manufacturer’s instructions on packages of laundry and cleaning aids. Heed all warnings or precautions. To reduce the risk of poisoning or chemical burns, keep them out of reach of children at all times (preferably in a locked cabinet).

24.Do not tumble fiberglass curtains and draperies unless the label says it can be done. If they are dried, wipe out the cylinder with a damp cloth to remove particles of fiberglass.

25.Always follow the fabric care instructions supplied by the garment manufacturer.

26.Never operate the tumbler with any guards and/or panels removed.

27.DO NOT operate the tumbler with missing or broken parts.

28.DO NOT bypass any safety devices.

29.Failure to install, maintain, and/or operate this machine according to the manufacturer’s instructions may result in conditions which can produce bodily injury and/or property damage.

30.Run tumbler with a load before putting tumbler into service.

WARNING

To reduce the risk of serious injury, install lockable door(s) to prevent public access to rear of tumblers.

W055

This machine is intended for commercial use.

6

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

M414545

Contents

Page Page SECTION Safety Introduction Installation Instructions Adjustments Operating Instructions Preventive Maintenance Instructions WARNING AVERTISSEMENT POUR VOTRE SÉCURITÉ il est •QUE FAIRE SI VOUS SENTEZ UNE ODEUR DE GAZ : –Ne pas tenter d’allumer d’apareil –Évacuez la pièce, le bâtiment ou la zone (SAVE THESE INSTRUCTIONS) GROUNDING INSTRUCTIONS DO NOT DRY DO NOT ALWAYS This machine is intended for commercial use Information in this manual is applicable to these tumbler models 30 Pound (28" Wide) (31.5" Wide) Page ROUGHING-INDIMENSIONS AND SPECIFICATIONS CABINET DIMENSIONS Exhaust Thimble Locations Steam Connection Locations Gas Connection Locations Electrical Connection Locations 28" wide Gas Tumbler 28" wide Electric Tumbler Gas Tumbler Electric Tumbler Steam Tumbler Page GAS, ELECTRIC OR STEAM DRYING TUMBLERS GAS DRYING TUMBLERS ONLY STEAM DRYING TUMBLERS ONLY NOTE: Do not throw these four capscrews away — they are the leveling legs Page FLOOR LAYOUT VENTING •Individual Venting DUCT •Collector Venting MAKE-UPAIR IMPORTANT: Do not obstruct the flow of combustion and ventilation air Page VERTICAL EXHAUST INSTALLATION •with CAN1-B149.1or CAN1-B149.2in Canada Page Page Page STEAM VALVE ELECTRICAL CONNECTIONS INSTALLING STEAM SOLENOID VALVE AND MAKING STEAM INLET CONNECTIONS INSTALLING STEAM TRAP AND MAKING CONDENSATE RETURN CONNECTIONS Page CAUTION Page JUMPER CONFIGURATION INSTRUCTIONS (OPL MICRO CONTROL MODELS ONLY) RING FERRITE INSTALLATION (GAS AND STEAM OPL MICRO CONTROL MODELS ONLY) Page NOTE: DO NOT use aluminum wire INSTALLATION OF NEW TIMING CAM No. of Pins in Cam REMOVAL OF EXISTING TIMING CAM Page COIN-OPERATEDTUMBLER Refer to Figure Page Page Page Page Page Page Page Page NONREVERSING CHAIN DRIVE MODELS NONREVERSING BELT DRIVE MODELS REVERSING MODELS Page To reduce the risk of fire: Coin Slide Models Electronic Control Models REVERSING OPERATION REVERSE CONTROL SWITCH INTRODUCTION Special Cycle Special Time NOTE: Not all tumblers will have reversing option Page STATUS LIGHTS, SIGNAL AND REVERSING DRYING LAUNDRY Page B.Time Dry and No Heat Cycles Range C.Special Cycle Mode D.Special Time Mode E.Custom SECURITY LOCK-OUT TEMPERATURE ADJUSTMENT Maximum Minimum Selection Page Page Notes Temperature Dryness Level/Time Page LINT REMOVAL Refer to Figure BELT TENSION LUBRICATION 2.On Energy Saver Gas Models: OVERALL CHECK ANY TIME TO CHECK FOR GAS LEAKS Page Page Page Page Page Page SECCIÓN Seguridad Introducción Instrucciones de instalación Ajustes Instrucciones de mantenimiento preventivo Instrucciones de operación ADVERTENCIA •QUÉ DEBE HACER SI HUELE A GAS: –No trate de encender ningún aparato –No toque ningún interruptor eléctrico; no use ningún teléfono del edificio –Haga salir a todos los ocupantes de la sala, edificio o área PARA SU SEGURIDAD (GUARDE ESTAS INSTRUCCIONES) INSTRUCCIONES DE PUESTA A TIERRA NO SEQUE SIEMPRE Esta máquina ha sido fabricada para uso comercial La información de este manual corresponde a estos modelos de secadora 30 libras (31,5 plg de ancho) Figura Page DIMENSIONES Y ESPECIFICACIONES DIMENSIONES DEL ARMARIO Dimensiones y especificaciones Ubicación de aberturas de escape Dimensiones y especificaciones Ubicación de conexiones de vapor Dimensiones y especificaciones Ubicación de conexiones de gas Ubicación de conexiones eléctricas Secadora de gas de 28 plg de ancho Secadora eléctrica de 28 plg de ancho Secadora de gas Secadora eléctrica Secadora de vapor Page SECADORAS DE GAS, ELÉCTRICAS O DE VAPOR SECADORAS DE GAS SOLAMENTE SECADORAS DE VAPOR SOLAMENTE NOTA: No tire los pernos – son las patas niveladoras Page PISO DISPOSICIÓN VENTILACIÓN 0,495 mm (0,0195 pulgadas) •Ventilación individual •Conducto colector de ventilación AIRE DE COMPLEMENTO IMPORTANTE: No obstruya el flujo de aire de combustión y ventilación Page Page INSTALACIÓN DEL ESCAPE VERTICAL Se deben desconectar la secadora y su •última edición de “National Fuel Gas Code”, ANSI Z223.1 en EE.UU •CAN1-B149.1o CAN1-B149.2en Canadá Page Page Page RECOMENDACIONES PARA COLOCACIÓN DE TUBERÍAS CONEXIONES ELÉCTRICAS PARA LA VÁLVULA DE VAPOR INSTALACIÓN DE UN PURGADOR DE CONDENSADO Y CONEXIONES DE RETORNO DEL CONDENSADO (10 pulgadas) por debajo de las conexiones de la salida del serpentín de vapor Tabla MODELO DE PRESIÓN DEL VAPOR PRECAUCIÓN Page INSTRUCCIONES DE CONFIGURACIÓN DEL PUENTE (MODELOS OPL MICRO CONTROL SOLAMENTE) Instrucciones de instalación: Page NOTA: NO UTILICE cable de aluminio DESMONTAJE DE LA LEVA DE SINCRONIZACIÓN EXISTENTE Page SECADORA CON OPL MICRO CONTROL SECADORA DE TEMPORIZADOR DUAL MANUAL Consulte la Figura SECADORA OPERADA CON MONEDAS Page Page Page Page Page Page Page SIN INVERSIÓN DE GIRO MODELOS DE ACCIONAMIENTO POR CADENA MODELOS DE ACCIONAMIENTO POR CORREA MODELOS CON INVERSIÓN DE GIRO Page Para reducir el riesgo de incendio: Modelos con deslizadora de monedas Modelos de control electrónico OPERACIÓN DE INVERSIÓN DE GIRO INTERRUPTOR DE CONTROL DE INVERSIÓN DE GIRO INTRODUCCIÓN NOTA: No todas las secadoras tendrán una opción de inversión de giro Page LUCES DE ESTADO, SEÑAL E INVERSIÓN DE GIRO (puerta abierta) (secado) (enfriamiento) (a la medida) Page B.Secado por tiempo y Sin calor Ciclos Gama C.Modalidad de ciclo especial D.Modalidad de tiempo especial E.A la medida BLOQUEO DE SEGURIDAD AJUSTE DE TEMPERATURA MODALIDAD MOSTRAR SENSOR DE TEMPERATURA Page Notas Page REMOCIÓN DE PELUSA LUBRICACIÓN 2.En modelos de gas con ahorro de energía: TENSIÓN DE LA CORREA COMPROBACIÓN GENERAL UNA LLAMA PARA COMPROBAR LAS FUGAS DE GAS Page LA SECADORA NO ARRANCA LA SECADORA NO CALIENTA LAS ROPAS NO ESTÁN LO SUFICIENTEMENTE SECAS