Allied Telesis AT-SBX31XZ4, X3112, AT-SBX31FAN, AT-SBX31GP24 manual Unpacking AT-SBx3112 Chassis

Chapter 2: Installation

Unpacking the

AT-SBx3112

Chassis

2.Identify the lowest 1/2” screw hole pattern on the rack mounting rails within the space reserved for the AT-SBx3112 Chassis. Install one rack mount screw in each vertical rail - at the same height in the top screw hole of the lowest 1/2” hole pattern as displayed in Figure 22. The screws are used to support the chassis while you secure it to the rack.

Screw
Head
6.4 mm (.25 in) away from rack
Top screw hole of the lowest 1/2” hole pattern	1791

Figure 22. Rack Mounting Hole Locations

Do NOT fully tighten these two screws at this time. The screw heads should protrude from the rack approximately 6.4 mm (.25 in).

To unpack the AT-SBx3112 Chassis, perform the following procedure:

1. Remove all components from the shipping package.

Note

Store the packaging material in a safe location. You must use the original shipping material if you need to return the unit to Allied Telesis.

52