American Power Conversion 3-in-1 Wireless Mobile Router manual

The Ethernet (WAN) Port Status

Connection Status - PPTP (Point-to-Point Tunneling Protocol) Screen

If using PPTP (Point-to-Point Tunneling Protocol), a screen similar to the following is displayed when the Status button is clicked.

		Figure 21. The PPTP Status Screen
The following table describes the fields on the PPTP Screen.

	Connection
	Physical Address	The hardware address of this device, as seen by remote devices on the Internet. (This is different
		from the hardware address seen by devices on the local LAN.)
	IP Address	The IP Address of this device, as seen from the Ethernet (WAN) Port interface. If using DHCP, and
		there is no current connection, this field will be blank or display 0.0.0.0.
	PPTP Status	Indicates whether or not the connection is currently established.
		If the connection does not exist, the Connect button can be used to establish a connection.
		If the connection currently exists, the Disconnect button can be used to break the connection.

	Connection Log
	Connection Log	The Connection Log shows status messages relating to the existing connection.
		The most common messages are listed in the section “The following table describes the Connection
		Log Messages..”
		The Clear Log button will restart the log, while the Refresh button will update the messages shown
		on screen.

	Buttons
	Clear Log	Deletes all data currently in the log, making it easier to read new messages.
	Connect	If not connected, establishes a connection to the ISP.
	Disconnect	If connected to the ISP, hangs up the connection.
	Refresh	Updates the data on screen.

4-14

Image 40

American Power Conversion 3-in-1 Wireless Mobile Router user manual Pptp Status Screen

Contents

User’s Manual Page Contents Configuring the Router for AP/Router Mode AP/Router Mode Advanced FeaturesConfiguring the Router for Client Mode Operation and Usage Appendix A. Troubleshooting and Maintenance A-1 List of Figures Contents of this Manual PrefaceIntended Audience Conventions and Typefaces Used in This Manual Regulatory Approvals Compliance StatementDisclaimers Trademarks Features WirelessRouter Mode Features Introduction Package Contents Physical Features Feature Functionality Modes Access Point AP Mode AP/Router Mode Config Mode Client Mode Modes How to Perform the Initial Configuration Initial ConfigurationRequirements Mode Configuration Screen Using The System Setup Screen Admin Using The Config File Screen System Upgrade Firmware Screen Upgrading the Firmware Upgrading the Firmware Configuring the Router for Access Point AP Mode Connecting the Router to a Wired or Wireless Network Wireless Using the Wireless Security Screen Wireless Security WEP Screen Using the Trusted Wireless Stations Screen Wireless Security WPA-PSK Screen Add EditClear Using the Trusted Wireless Stations Screen Configuring the Router for AP/Router Mode Connecting in AP/Router Mode Using the AP/Router Setup Screen AP/Router Setup Screen Wireless LAN Ethernet WAN Port Wireless Security Screen Security System WEP Security System WPA-PSK Trusted Wireless Stations Screen Buttons Ethernet WAN Port Configuration Screen Connection Type Travel Mode HotelConnection Type IP Address MAC Address Connection Types PPPoE, PPTP, L2TP, and No LoginIdentification Ethernet Port Configuration All Settings Connection Behavior Ethernet WAN Port Configuration Screen Internet Ethernet WAN Port StatusFixed/Dynamic IP Address Connection Connection Log Message Description Pptp Status Pptp Status Screen Connection Status L2TP Screen L2TP Status Screen Ethernet WAN Port Status AP/Router Mode Advanced Features Advanced Internet ScreenCommunication Applications Communication Applications Enable DMZ using Port ForwardingSend Application’s incoming calls to My PC is not listed IP Address Seen by Internet Users Port Forwarding Port Forwarding Screen ServiceProperties Using Self-defined Servers Connecting to User-defined ServersCreate a new Server Modify Edit a Server Using Dynamic DNS Domain Name Server Ddns Screen Ddns Service Ddns Data Ping Network Diagnostics ScreenDNS Lookup Backup DNS Backup DNS IPEnable UPnP Services Options Screen Advanced PC Database Screen Advanced PC Database Screen PC Properties Firewall Security ScreenOptions Allow Pptp Allow L2TP Security Screen Configuring the Router for Client Mode Connecting the Computer to the Router Wireless Profiles Client Mode Setup ScreenSet as Current Wireless Client Profile Screen GeneralProfile Name Network Type Security Security Sytem Using AP Mode When Changing ModesOperation and Usage Using AP/Router Mode Connecting in AP/Router Mode AP/Router Setup Screen annotated Using Client Mode Appendix a Troubleshooting and Maintenance General ProblemsWireless Access AP or AP/Router Mode Solution Router Mode Problem 3 The wireless connections speed is very slow Modes for Wireless LANs Appendix B About Wireless LANsBasic Service Set BSS and Extended Service Set ESS Off, 64 Bit, 128 Bit Wired Equivalent Privacy WEPOpen System or Shared Key Appendix C Specifications Wireless Interface Specifications Warranty Technical Support