Speed

5.7 Controlling the camera speed

Controlling the Camera

5.7.1 Speed / compensation off

The camera speed can be manually adjusted within the pre-defined end-stops of the handwheel.

Differences in exposure are not automatically compensated for.

The main menu shows ‘SPEED’ in the first display line, and the currently adjusted camera speed in the second display line.

By pressing the SET button, the currently set shutter angle (if controlled by the WRC-1) can be shown in the first display line and the currently set T-stop (if controlled by the WRC-1) is shown in the second display line.

Note

The following warnings may be displayed:

 

‘IRIS TBL’ – a valid iris table has not yet been

 

activated;

 

readings with ‘NO’ in the first display line

 

indicate that the selected function is currently

 

not available (example: ‘NO IRIS’ although the

iris control is activated on the WRC-1, the iris motor has not yet been connected); readings with ‘RANGE’ in the second display line indicate that the adjustment range of a parameter has been exceeded (example: the selected speed is not available with this camera); readings with ‘OFF’ in the first display line indicate that this function is deactivated on the camera (example: shutter angle of the 435 is set manually = ‘OFF ANGLE’).

Correct parameters must be set before the camera is started!

•Press the MODE button in the main menu to enter the first submenu. The end-stops for the handwheel (mini- mum and maximum camera speed) can be defined.

The first display line shows the value for the left handwheel end-stop, the second line shows the value for the right end-stop.

104