Warnings

No iris motor is connected to the UMC-1, a CLM-1 is connected as the iris motor,

or the IRIS sliding switch is set to OFF and a function has been selected which requires the iris to be controlled

or the calibration process is running. Connect a CLM-2 iris motor,

or set the IRIS sliding switch to ON and then switch the WRC-1 (and WMU-1) off and on again to reset the units, or select a WRC function which does not require an iris control.

Command to calibrate the lens.

Press the CAL button on the WMU-1.

An iris table is not activated.

Connect the iris control as described in chapter 4.1.2, calibrate the lens and assign the T-stops as described in chapter 5.5.1!

166