•Press the MODE button to go to the next submenu.

To define the fixed value for the aperture of the lens (if controlled by the WRC-1), use the SEL and SET buttons and the handwheel, as described above.

•Press the MODE button to go to the next submenu. To enter the ramp duration, use the SEL and SET buttons and the handwheel, as described above.

 

A previously set ramp duration may now exceed

 

the technically fastest possible adjustment, if the

 

ramp duration is simply kept from an old

 

program. The READY LED then flashes green

 

and the warning ‘SEC RANGE’ is shown in the

 

main menu. The ramp duration must be cor-

 

rected. The camera can still be started for test

 

purposes in spite of the flashing warning.

 

However, the exposure may be incorrect!

Note:

The shortest possible ramp time is adjusted by

 

turning the handwheel to the left end-stop. The

 

maximum ramp time is 100 seconds.

•Press the MODE button to go to the next submenu. The screen time for the selected ramp duration can be displayed.

The screen time is the time (in seconds) needed for a projection at a selected standard projection speed: 24, 25 and 30 fps are available.

•Press the SEL button for longer than 2 seconds to select the required projection speed. Press the SEL button repeatedly to switch between the three available values. The selected projection speed is confirmed by pressing the SET button.

•Press the MODE button to go back to the main menu.

Controlling the Camera Speed

139