Note

The following warnings may be displayed:

 

‘IRIS TBL’ – a valid iris table has not yet been

 

activated;

 

readings with ‘NO’ in the first display line

 

indicate that the selected function is currently

 

not available (example: ‘NO IRIS’ although the

 

iris control is activated on the WRC-1, the iris

 

motor has not yet been connected);

 

readings with ‘RANGE’ in the second display

 

line indicate that the adjustment range of a

 

parameter has been exceeded (example: the

 

selected speed is not available with this camera);

 

readings with ‘OFF’ in the first display line

 

indicate that this function is deactivated on the

 

camera (example: shutter angle of the 435 is

 

set manually = ‘OFF ANGLE’).

 

Correct parameters must be set before the

 

camera is started!

The handwheel is without function in the main menu. Press the RAMP button when the camera is running to start the ramp. The camera can be started, by pressing the RUN button on the WMU-1.

The ramp can be reversed, by pressing the RAMP button again: the ramp then reverses its direction until it reaches the start value again. For best results wait until the end of the ramp.

Press the MODE button in the main menu to enter the first submenu. The limit values for the minimum and maximum shutter angle can be defined.

The first display line shows the start value of the shutter angle, and the second line the value at the end of the ramp.

Press the SEL button for longer than 2 seconds.

The shutter angle value in the first display line flashes. The required value can now be set using the handwheel. Press the SEL button again to switch to the next digit.

The first digits are confirmed, and the decimal is set to ‘0’ by pressing the SET button.

The values in the second display line can be set accordingly.

Controlling the Shutter Angle

89