set manually = ‘OFF ANGLE’).

Correct parameters must be set before the camera is started!

By pressing the SET button, the currently set T-stop (if controlled by the WRC-1) can be displayed in the first display line, and the currently set camera speed is shown in the second display line.

•Press the MODE button in the main menu to enter the first submenu. The limit values for the left and right end-stop of the handwheel (minimum and maximum mirror shutter angle) can be defined.

The first display line shows the value for the left handwheel end-stop, the second line shows the value for the right end-stop.

•Press the SEL button for longer than 2 seconds.

The shutter angle value in the first display line flashes. The required value can now be set using the handwheel. Press the SEL button again to switch to the next digit.

The first digits are confirmed, and the decimal is set to ‘0’ by pressing the SET button.

The values in the second display line can be set accordingly.

•Press the MODE button to go to the next submenu. To define the fixed values for the aperture of the lens (if controlled by the WRC-1) and the camera speed, use the SEL and SET buttons and the handwheel, as described above.

The display shows full T-stops followed by the tenth of a T-stop. Example: T-stop 2.8 plus half a T-stop is shown as 2.8_5. The tenths of a T-stop are linearly divided between the two full T-stop positions.

•Press the MODE button to go back to the main menu.

Controlling the Shutter Angle

79