Note

The following warnings may be displayed:

 

‘IRIS TBL’ – a valid iris table has not yet been

 

activated;

 

readings with ‘NO’ in the first display line

 

indicate that the selected function is currently

 

not available (example: ‘NO IRIS’ although the

 

iris control is activated on the WRC-1, the iris

 

motor has not yet been connected);

 

readings with ‘RANGE’ in the second display

 

line indicate that the adjustment range of a

 

parameter has been exceeded (example: the

 

selected speed is not available with this camera);

 

readings with ‘OFF’ in the first display line

 

indicate that this function is deactivated on the

 

camera (example: shutter angle of the 435 is

 

set manually = ‘OFF ANGLE’).

 

Correct parameters must be set before the

 

camera is started!

•Press the MODE button in the main menu to enter the first submenu. The limit values for the left and right end-stop of the handwheel (minimum and maximum camera speed) can be defined.

The first display line shows the value for the left end-stop, the second line shows the value for the right end-stop.

•Press the SEL button for longer than 2 seconds.

The first digits in the first display line flash. The required value can now be set using the handwheel. Press the SEL button again to switch to the next digit. The first digits are confirmed, and the decimal positions are set to ‘0’ by pressing the SET button. The values in the second display line can be set accordingly.

•Press the MODE button to go to the next submenu. The limit values for the mirror shutter angle can be defined.

The shutter angle is automatically adjusted to compensate the exposure while the camera speed is adjusted with the handwheel. One of the two limit values (minimum or maximum shutter angle, depending on the adjustment direction of the camera speed) can be defined; the other limit value is automatically calculated by the WRC-1. Press the SEL button for longer than 2 seconds. Depending on the definable limit value, the shutter angle display flashes in the first or second display line. This can now be set using the handwheel. The auto- matically calculated other limit value is shown in the other display line. Press the SEL button again to switch to the next digit. The selected shutter angle is confirmed and the decimal is set to ‘0’ by pressing the SET button. The minimum shutter angle corresponds to the selected minimum camera speed.

Controlling the Camera Speed

111