
Controlling the Iris
Note: | If the |
| it is sufficient to enter just two |
| be at least four |
| the iris table. If the |
| the |
| After programming the iris table, all individual |
| |
| with the handwheel in order to avoid incorrect |
| exposures! |
Note: | If the lens has a CLOSE position, this must also |
| be defined, as the iris table only applies up to |
| the last value before the CLOSE position! When |
| assigning, the CLOSE position is programmed |
| after the highest possible |
Note: | For compensating the exposure, only the range |
| between full |
| iris scale of the lens reaches from T2.2 to 22. |
| The values for T4 and T16 are assigned. The |
| resulting usable range reaches from T2.8 to |
| T22, as T2.2 is not a |
|
Note: | If a |
| cannot be correct, a warning is displayed; e.g. |
| |
| incorrectly positioned value must be deleted. |
If the iris table should remain available after using another lens, it must be stored as described below. This also applies when an iris table has been
46