Controlling the Camera Speed

Press the MODE button to go to the next submenu. To enter the ramp duration, use the SEL and SET buttons and the handwheel, as described above.

A previously set ramp duration may now exceed the technically fastest possible adjustment, if the ramp duration is simply kept from an old program. The READY LED then flashes green and the warning ‘SEC RANGE’ is shown in the main menu. The ramp duration must be cor- rected. The camera can still be started for test purposes in spite of the flashing warning. However, the exposure may be incorrect!

Note:

The shortest possible ramp time is adjusted by

 

turning the handwheel to the left end-stop. The

 

maximum ramp time is 100 seconds.

Note:

While the ramp duration is being set, the display

 

shows the automatically calculated screen time

 

in the first display line, which corresponds to the

 

selected projection speed (see the next two

 

bullet points).

Press the MODE button to go to the next submenu. The screen time for the selected ramp duration can be displayed.

The screen time is the time (in seconds) needed for a projection at a selected standard projection speed: 24, 25 and 30 fps are available.

Press the SEL button for longer than 2 seconds to select the required projection speed. Press the SEL button repeatedly to switch between the three available values. The selected projection speed is confirmed by pressing the SET button.

Press the MODE button to go back to the main menu.

162