Note | The following warnings may be displayed: |
| ‘IRIS TBL’ – a valid iris table has not yet been |
| activated; |
| readings with ‘NO’ in the first display line |
| indicate that the selected function is currently |
| not available (example: ‘NO IRIS’ although the |
| iris control is activated on the |
| motor has not yet been connected); |
| readings with ‘RANGE’ in the second display |
| line indicate that the adjustment range of a |
| parameter has been exceeded (example: the |
| selected speed is not available with this camera); |
| readings with ‘OFF’ in the first display line |
| indicate that this function is deactivated on the |
| camera (example: shutter angle of the 435 is |
| set manually = ‘OFF ANGLE’). |
| Correct parameters must be set before the |
| camera is started! |
The handwheel is without function in the main menu. Press the RAMP button when the camera is running to start the ramp. The camera can be started, by pressing the RUN button on the
The ramp can be reversed, by pressing the RAMP button again: the ramp then reverses its direction until it reaches the start value again. For best results wait until the end of the ramp.
•Press the MODE button in the main menu to enter the first submenu. The limit values for the minimum and maximum camera speed can be defined.
The first display line shows the start value of the camera speed, and the second line the value at the end of the ramp.
•Press the SEL button for longer than 2 seconds. The first digits in the first display line flash.
The required value can now be set using the handwheel. Press the SEL button again to switch to the next digits. The first digits are confirmed, and the decimal positions are set to ‘0’ by pressing the SET button. The values in the second display line can be set accordingly.
Controlling the Camera Speed
129