Avaya 580, 882 Editing AppleTalk Interfaces

Document No. 10-300077, Issue 2 19-7
Configuring AppleTalk Routing
CLI Commands U se the following CLI commands i n interface mode to create an Ap pleTalk
interface:
■(config-if:<interface-name>)# appletalk cable-range
<cable-range>
■(config-if:<interface-name>)# appletalk address
<network.node>
■(config-if:<interface-name>)# appletalk zone <zone-
name>
■(config-if:<interface-name>)# appletalk vlan <vlan-
id>
Editing AppleTalk Interfaces
You can edit AppleTalk interfaces using either the Web Agent or the CLI.
Web Agent
Procedure To edit an AppleTalk interface using the Web Agent:
* Note: You must enable AppleTalk globally and create an AppleTalk
interface before you can edit an inter fa ce. See “Enabling
AppleTalk Global Routing” and “Creating an AppleTalk
Routing Interface” earlier in this chapter.
1. In the navigation pane, expand the Routing > AppleTalk >
Configuration folders, and then click Interfaces.
The AppleTalk Interfaces Web page is displayed in the content pane.
See Figure 19-4.
2. If there is no zone to select or if you want to edit the zones available,
complete this step through step x. If not, skip to step x+1. Select Edit
Zone to edit the AppleTalk zone for this interface.
The Edit AppleTalk Zone Web page is displayed. See Figure 19-5.
Figure 19-5. Edit AppleTalk Zone Web Page