Brady 3481, 6441, 2461 manual HEX Dump Mode, Options Testing, Print Test Rate MIN, Sensor Readings

4.1.7			Diagnostics
HEX DUMP MODE						Most commonly used for troubleshooting.
						Prints data and instructions received from
						the host rather than interpreting them as
						label formats; see Section 6.2.
	ENABLE					Prints raw ASCII data received from the
						host rather than executing the commands.
	²DISABLE					Executes and prints label formats (normal
						operating mode).
OPTIONS TESTING						Tests currently installed options
	TEST PRESENT SENSOR					Performs a functional test of the Present
						Sensor circuitry.
	TEST CUTTER					Performs a functional test of the optional
						cutter mechanism and circuitry.
		PERFORM TEST				The cutter will cycle 1, 10 or 100 times
		1 TIME				(selectable). The results of each attempt
						will be displayed.
	MONITOR GPIO INPUT
	TEST GPIO OUTPUTS
PRINT TEST RATE					(MIN)	The number of minutes to delay between
²0			(0-120)			the printing of batches of labels in Quick
						Test Mode.
SENSOR READINGS						Analog Sensor readings are displayed.
	THR TRAN RIBM 24V à					Live sensor values are displayed. View
	255		255	255 255		can be toggled with forward and reverse
						keys. Maximum values are shown in this
						example: thermistor sensor, transmissive
						(gap) media sensor (TRAN is replaced
						with REFL when the SENSOR TYPE is set
						to ‘reflective’), ribbon sensor, 24 volt
						power supply sensor.
	ß PS HD			RANK		Present sensor, head down sensor,
	255 255			255		printhead ranking resistor.
RIBBON SENSOR LIMITS						Displays ribbon sensor ADC low and high
						values used for motion detection.
	RIBBON ADC LOW HIGH					Approximate default values are shown
				070	164	here (actual values will vary).
						53