Brady 2461, 3481, 6441 manual Step, Operator Action, Displayed Message, Comment

Advanced Entry Calibration (continued)

Step	Operator Action					Displayed Message	Comment
16	Press the		key.				The selection
							will flash and
	Using the		or the				the display
					â
		key, set the					heading will
	‘Paper’ level to the value						change to
	determined in the previous						indicate the
					â
	step. Press the			key			item for entry.
	to set the entry (indicated
	by the ‘*’) and advance the
	menu.					Or, for reflective media:

Repeat for the ‘Gap’ (or ‘Mark’) and ‘Empty’ levels.

â

â

17 After all entries have been	From ‘Ready’,
made, press the	press the FEED
key to back out of the menu	key to advance
and then press the	to the next label
key to save the settings and	TOF.
return to the Ready Mode.

þNote: If the Advanced Entry Calibration fails, try the following procedure.

Re-enter Media Settings / Calibration / Advanced Entry / Sensor Gain and lower the selected Gain Setting number by one (to make the sensor less sensitive). Select the new Gain Setting, save the changes, exit the menu, and then test your media. Repeat the procedure until a usable media setting is obtained.

70