Brady 2461, 3481, 6441 manual Die-cut stock strip, Value

Advanced Entry Calibration (continued)

Step	Operator Action		Displayed Message	Comment
11	Proceed according to			Where ‘yyy’ is a
	your media type:			numerical value
	Die-cut stock: strip the			representing the
			Or, for reflective media:
				current sensor
	media from the backing
				reading: useful in
	and then reinsert it into
				locating the best
	the sensor; adjust the
				sensor position.
	Sensor Eye Mark over
	the center of the backing.
				þ Note: Never
	Notched stock: adjust
				position the
	the Sensor Eye Mark			sensor over a
	over the center of the			perforation when
	notch.			recording a
	Reflective stock: Adjust			sensor reading.
	the Sensor Eye Mark
	over the center of the
	facedown black mark.
	Press the	key
	to select the setting and
	then record the sensor
	reading in a table similar
	to the one shown after
	Step 12, as a TOF
	Value.

Next, press the key to increment the Gain Number.

Repeat for each of the

Gain Numbers (00-32).

þNote: Do not move the position of the Media Sensor after it has been adjusted.

67