Warning Messages:
Warning Messages are displayed for a period of five seconds. If multiple Warnings are detected, the display will reflect the highest priority message.
Printer Warning Messages
| Displayed Message | Description | Action(s) | |
|
|
| The printer has | Replace the printhead if the |
|
|
| detected defective | print quality becomes |
|
|
| printhead elements. | unacceptable. |
|
|
| ||
|
|
| ||
|
|
|
|
|
|
|
| The printer measured | Transparent backing or |
|
|
| ||
|
|
| only a small | notched media typically |
|
|
| difference between | gives this indication. In this |
|
|
| ||
|
|
| the ‘empty’ and ‘gap’ | case, there may be a slight |
|
|
| sensor readings. | delay in the ‘Out of Stock’ |
|
|
|
| indication, after the media |
|
|
|
| supply is emptied; no |
|
|
|
| action is required. |
|
|
|
|
|
|
|
| Power has been | The printer power switch |
|
|
| removed and | was turned ‘Off’, the line |
|
|
| shutdown is in | fuse has blown, or AC line |
|
|
| ||
|
|
| ||
|
|
| progress. | voltage has been lost. |
|
|
|
|
|
|
|
| The host has pending | To save changes, send a host |
|
|
| configuration | reset command (in DPL), or |
|
|
| changes that will not | to discard changes perform a |
|
|
| ||
|
|
| ||
|
|
| take effect until a | soft reset; see Section |
|
|
| ‘host reset command’ | 4.0.6.1. |
|
|
| is issued. |
|
|
|
|
|
|
|
|
| The printer has | Possible low or fluctuating |
|
|
| detected a low | line voltage level. Try |
|
|
| operating voltage. | moving the printer to |
|
|
| ||
|
|
| ||
|
|
|
| another outlet. If the |
|
|
|
| condition persists, call for |
|
|
|
| service. |
|
|
|
|
|
|
|
| The printer was | Possible faulty Main PCB. |
|
|
| unable to save | If the condition persists, call |
|
|
| settings in permanent | for service. |
|
|
| ||
|
|
| ||
|
|
| memory. |
|
|
|
|
|
|
|
|
| A high printhead | No action required. |
|
|
| ||
|
|
| temperature has been |
|
|
|
| detected. |
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
92 |
|
|
| |
