Brady 6441, 3481, 2461 manual Roll Media

3.1.1Roll Media

This loading method is roll type media applications. To load:

ΠSlide the Roll Media

onto the Media Hub

until it rests against the

Backstop.

• Route the media as shown: under the Media Idler, through the Media Sensor, then out the front of the printer.

Ž Raise and slide the Media Guide over until

it rests lightly against the edge of the media.

•Position the Media Sensor; see Section 3.2.

•If your application uses thermal transfer media, load ribbon (see Section 3.3); otherwise continue.

‘Lower the Printhead Assembly and rotate the Printhead Latch completely back into the locked position. Close the Access Cover.

’Turn ‘On’ the printer. After ‘Ready is displayed, press and hold the FEED key until at least one label gap or mark is advanced; see Section 3.4.

+If using less than full width media, adjust the Leveling Cam; see Section 5.1.1.

15