Cabletron Systems 9A000 manual Chapter Switch Setup

Contents

3.2.4.2 SFCS-1000 AC Power Supply (Model A)				3-12
3.2.4.3 SFCS-1000 AC Power Supply (Model B)				3-15
3.2.5	SFCS-1000		Fan Tray	3-18
3.2.6	SFCS-1000		Temperature Sensing	3-18
3.2.7 SFCS-1000 Common Equipment Card (CEC)				3-19
3.2.7.1		CEC Front Panel		3-19
3.2.7.2		Alarm Relay Contacts		3-19
3.2.7.3		CEC Status LEDs		3-21
3.2.7.4		Ethernet Port		3-22

Chapter 4	Switch Setup
	4.2	Unpacking		4-1
		4.2.1	Inventorying the Unit	4-2
	4.3	Electrical Considerations		4-3
	4.4	Rack-Mounting an SFCS-200BX		4-4
		4.4.1	Required Tools	4-4
		4.4.2 Installing the Rack-mount Brackets		4-5
	4.5	Rack-Mounting an SFCS-200WG		4-7
		4.5.1	Required Tools	4-7
		4.5.2 Installing the Rack-mount Brackets		4-8
	4.6	Rack-Mounting an SFCS-1000		4-10
		4.6.1	Installing the SFCS-1000	4-11
	4.7	Installing the Serial Cable		4-12
	4.8	Modem Configuration		4-13
		4.8.1	Modem Parameters	4-13
	4.9	Configuring IP Addresses		4-14
	4.10	AMI Security		4-15
	4.11	Subsequent Operation		4-15
	4.12	Verifying the Installation		4-16
	4.13	Product Registration Information		4-16

Chapter 5	Hardware Maintenance Procedures
		5.1.1	Overview	5-1
		5.1.2	Multicast Mode	5-2
		5.1.3	Hot-swapping Network Modules	5-3
	5.2	Power Supply Module Replacement		5-4
		5.2.1 SFCS-200BX Power Supply Module Replacement		5-4
		5.2.1.1 Replacing an SFCS-200BX AC Power Supply		5-4
		5.2.2 SFCS-1000 Power Supply Module Replacement		5-6
		5.2.2.1 Replacing an SFCS-1000 AC Power Supply (Model A)		5-6
		5.2.2.2 Replacing an SFCS-1000 AC Power Supply (Model B)		5-9
	5.3	SFCS-1000 Fan Tray Replacement		5-12
	5.4	Switch Control Processor Replacement		5-13
	5.5	Switch Board Replacement		5-15

iv