Cisco Systems 3000 manual Center Table segment

Chapter 6 Building the Table Assembly

Building the Table Assembly, Product ID CTS3K-M

Step 8 Attach the center Table segment.

a.Make sure you tighten the draw bolt evenly on both sides.

b.While a draw bolt is being tightened, hold the table edges together to avoid damage to the draw bolt or the table segment.

c.Tighten the draw bolts so the two table segments are connected snugly.

d.While one person is tightening the draw bolt from below, it is important for the support person to maintain the alignment of the table segment edges.

Note The splines have different lengths. Use a spline that is slightly smaller than the slot in the table top.

Figure 21 Center Table segment

6

5

12

204139

10

	Cisco TelePresence System 3000
OL-14521-01		6-25