Cisco Systems 3000 manual Replacing a Plasma Display-Part Number CTS-DISP-65-GEN2, 11-3

Chapter 11 Field-Replaceable Unit Guide

Replacing a Plasma Display—Part Number CTS-DISP-65-GEN2

Step 6 Reattach the Ethernet and signal cables according to your temporary markings.

Do not attach the camera hoods at this time.

Step 7 Open a browser on a computer connected to the network.

Step 8 Type in the IP address of the center, primary codec unit. Enter the required information at the login screen.

Step 9 The Cisco TelePresence Administrator window appears. Verify the status of the Cisco Unified Communication Manager (seen in the lower left portion of the window) is Enabled/Up.

Step 10 Select Hardware Setup to verify the cameras, displays, speakers, and microphones are working properly.

Step 11 Perform the camera adjustment procedure.

See the “Setting Up the Cameras” section on page 9-7for more information.

Step 12 Re-attach the camera hood and lens hood.

Caution Do not overtighten the screws, or use a power screwdriver to tighten the screws. In addition, make sure that you use screws of the correct length (20 mm). Overtightening the screws, or using a screw that is too long, can cause the plastic hoods to break.

Step 13 Power on the system by turning the power switches to the On position on the two left PDUs, single right PDU, and (if present) auxiliary control unit or PDU on the rear center of the display assembly.

Replacing a Plasma Display—Part Number CTS-DISP-65-GEN2

Required Information, Tools, and Equipment

To disassemble and reassemble portions of the Cisco TelePresence 3000 to replace a display, you need the following information, tools, and equipment:

•Release Notes for Cisco TelePresence System, Release 1.4, OL-12074-05

•Cisco TelePresence System Release 1.4 Administrator’s Guide, OL-13676-03

Uncrating and unpacking:

•Claw hammer or small pry bar

•Large Phillips screwdriver

•* Tin snips

•* Pallet jack or hand cart (for moving components)

•* Safety gloves

•* Safety glasses

•* Box cutters

	Cisco TelePresence System 3000
OL-14521-01		11-3